Project #255 – Canvas Circle Skirt

I love making circle skirts when I have fabric that is at least 59 inches across. They can be cut in just one piece if you buy two yards. That means that just the waist and hem need to be finished in order to leave you with a finished garment.

Plus, circle skirts are great. Swish. Swish. Swish.

[I shortsightedly forgot to take pictures of the process of making this skirt. If the directions aren't clear, they're very similar to my illustrated ones for a circle skirt template.]

Cutting out a circle skirt isn’t hard. You’ll just need a yardstick, some chalk and a little patience. First, fold your fabric to find the center point. Mark that.

Now, if you have two yards of fabric, it should be 72 inches long and (ideally) about 59 inches wide. If you want to go for the maximum length*, then mark the edge of the fabric 29.5 inches across the width in one direction and 29.5 inches in the other. Now, mark 29.5 inches from the center across the length at a 90 degree angle from the two width-wise marks. Do that again for the opposite end. Now you will have a center mark and four additional ones laid out in a ‘+’ shaped configuration. Make some more marks to fill in the edge of your circle, pivoting the yardstick around the center mark and going out 29.5 inches. Cut along your marks.

Now you have a giant flat circle that needs the center cut out so you can actually wear it. Measure yourself at your hips. This will be at least how wide the skirt must be so that you can step into it to put it on. To figure out how big it should be I used the circumference equation, circumference = 2πr. I substituted my hip size for the circumference and solved for r and got about 6 inches, so my diameter will be 12 inches. I cut the smaller circle out using the same center point technique as the outer circle.

Fold down the edge of the inner circle to form a casing for elastic. Clip if you need a little give to make the casing lay flat, sort of making shallow sun rays from the inner circle. Sew in place, leaving a 1 inch opening. String narrow elastic through the casing and adjust so that the skirt sits comfortably at your waist; give yourself a little breathing room. Clip the extra elastic and sew the ends together. Tuck the elastic into the casing and sew the 1 inch opening shut.

Finally, just the hem is left. Folding up fabric to make a hem on a circle skirt is always kind of a pain. It’s always annoying tying to ease in the excess fabric from the edge and it’s usually about nine yards of sewing. No thanks. Instead, my edge finish of choice is bias tape. It adds a little contrast and no easing is necessary.

If you’re not familiar with sewing with bias tape I learned how to apply it properly from this tutorial.

*I always recommend going for the maximum length at first. It’s easy to remove excess length, but not vice versa.


No Comments so far.

Leave a Reply